When creating Route Steps you can create and access Route Variables.

Noojee Contact creates a number of System Route Variables as part of call setup.

The following System Variables are available:

System Route Variables:

Routes provide a number of default system variables which can be access to determine information pertaining to the current call or the system as a whole. The following variables can be access by calling getVariable(variableName).

Please note that these variables are readonly and as such you can't update them.

The system may update some of these Route Variables as a call progresses through a route.

Variable Name	Description	Scope
nj.TargetMatch	When a call is initially routed or Gosub is called the value in nj.DialTarget is used to pattern match against possible Target Matches in the context. When a specific Target Match is selected 'nj.TargetMatch' is set to the value of the Target Match that matched the DialTarget. e.g. nj.DialTarget might be: 03 8320 8100 but nj.TargetMatch might be 03 XXXX XXXX.	Gosub
nj.DialedNo	The number that was dialed to cause the current call. For an inbound call this will be the DID for an outbound call this will be the no. dialed from the staff members handset. The dialed no. will not change over the life of a call.	Call
nj.SourceRealm	Set by the Trunk through which the call entered the system. Even calls from internal extensions (handsets) enter Routes via a Trunk. The Realm is used to determine the direction of the call. The system uses the Source realm and the Delivered To realm to determine the direction of the call. The systems ability to determine a calls direction is important when determining whether a call should be recorded for an Account as well as for general reporting purposes. It should be noted that superficially it would appear to be quite easy to determine a calls direction however in practices it can be quite complicated as a call can actually changed direction mid way through the call. Realms are INTERNAL,EXTERNAL	Call
nj.Direction	Reflects the direction of the call. The direction of a call is not as simple as it might look as a call can changed directions as the call progresses. e.g. an inbound call is re-routed to an external call. It then becomes a 'PASS_THRU' call. INTERNAL - call between two handsets OUTBOUND - call to an outside number PASS_THRU - a call that has passed into then out of the system. INBOUND - a call from an external party into the system.
nj.SourceNo	Set by the core routing each time a call is originated. For inbound calls this is the caller id, for calls dialed from a handset this is the handset extension no. This does not change during the life of the call.	Call
nj.DialTarget	The DialTarget typically starts out with the same value as the 'nj.DialedNo' but unlike nj.DialedNo the variable nj.DialTarget is updated each time the Gosub command is called. nj.DialTarget is updated to match the second argument of the Gosub command (context, dialTarget). When a Gosub returns it will reset the nj.DialTarget variable to the value it was before Gosub was called.	Gosub
nj.CompanyName	Contains the value of the system variable which contains the Company Name of the organisation that the PBX runs for.
nj.SupportEmail	Contains the value of the system variable SupportEmail - the email address that support emails are sent to.
nj.AdministratorEmail	Contains the value of the system variable AdministratorEmail - the email address that admin emails are sent to.

Browser not supported